Finished wiring the GEA 24, GAD 29, and GAD 25

Made up harnesses for the TO/GA button and panel light dimmer switches. I mounted them back in the center panel and wired the corresponding connectors under the panel. I used micro molex connectors to make the connections.

I received the stranded thermocouple wire I ordered from McMaster Carr. SO I was able to finish wiring up the GEA 24.

I wired up the GAD 29.

I wired up the GAD 27.

Making progress. Glad I made this wiring list. It’s been super helpful as a reference and to keep track of my progress. The terminations highlighted in green are complete.

Today’s Time (hours):	10.0
Finish Kit (hours):	138.0
Total Time (hours):	868.0

Wired the radio stack

Made my first CAN Bus daisy chain termination for the GTR 200B com radio.

Finished wiring the COM radio connector.

Terminated the antenna cables with BNC connectors for the transponder and com radio and a TNC connector for the GPS.

Made up the connector for the GMC 507 autopilot control. Pretty simple… Power, Ground and CAN bus.

Installed the com radio tray and the transponder and GPS trays that I had pre-wired. I routed and tied all the wires.

60774312142__02fadbcc-4ae2-43bc-9aa6-b8e65444c2cf

Today’s Time (hours):	8.0
Finish Kit (hours):	120.0
Total Time (hours):	850.0

Progress continues on wiring

I’ve neglected to post over the past week. Been a busy week at work. I have made some good progress though.

I vinyl-wrapped the fuse block panel and screwed the fuse block into it. I made a bus bar from a strip of copper to tie together the upper and lower buses of the fuse block.

I drilled some system holes through the left seat ribs, installed snap bushings, and ran the pitot and AOA lines from the wing root to the panel.

Drilled a couple of system holes in the lower sub-panel. Routed the the wires for the battery backup. Terminated the grounds for the the IBBS and the IBBS master switch.

Made up the connectors for the GTX 45R transponder and the GTN 625 GPS. I also started on the GTR 200B COM radio but didn’t get a picture.

Today’s Time (hours):	6.0
Finish Kit (hours):	112.0
Total Time (hours):	842.0