Wired the radio stack

Made my first CAN Bus daisy chain termination for the GTR 200B com radio.

 

Finished wiring the COM radio connector.

 

Terminated the antenna cables with BNC connectors for the transponder and com radio and a TNC connector for the GPS.

 

Made up the connector for the GMC 507 autopilot control. Pretty simple… Power, Ground and CAN bus.

img_4532

 

Installed the com radio tray and the transponder and GPS trays that I had pre-wired. I routed and tied all the wires.

 

Today’s Time (hours): 8.0
Finish Kit (hours): 120.0
Total Time (hours): 850.0

 

More wiring

Run the left side of the main harness. Terminated the antenna connections; TNC for the GPS and BNC for the com and transponder. Only did the antenna side. I’ll get the panel end when I wire the panel.

 

Getting the snap bushings into the wire guides was a huge pain in the ass. super tight. especially with the additional can bus wire. I ended up pulling that wire out and getting the snap bushings in. Once they were in I was able to push the can bus cable through.

img_4109

 

On a brighter note, my seats came in today. Abby at Flightline Interiors did an amazing job. Very happy.

img_4107

 

Today’s Time (hours): 2.0
Options and Miscellanea Time (hours): 46.0
Total Time (hours): 735.0