More wiring

Run the left side of the main harness. Terminated the antenna connections; TNC for the GPS and BNC for the com and transponder. Only did the antenna side. I’ll get the panel end when I wire the panel.

 

Getting the snap bushings into the wire guides was a huge pain in the ass. super tight. especially with the additional can bus wire. I ended up pulling that wire out and getting the snap bushings in. Once they were in I was able to push the can bus cable through.

img_4109

 

On a brighter note, my seats came in today. Abby at Flightline Interiors did an amazing job. Very happy.

img_4107

 

Today’s Time (hours): 2.0
Options and Miscellanea Time (hours): 46.0
Total Time (hours): 735.0

 

 

Wiring Continues

Ran the right harness up to the co-pilot’s control stick. This required filing out a number of holes along the way to enable the connector to fit through.  I also ran the wires for the GPS, transponder, and com radio.

 

Today’s Time (hours): 3.0
Options and Miscellanea Time (hours): 44.0
Total Time (hours): 733.0