Finished riveting the bottom left skins

Finished riveting the forward half of the outboard left skin.

img_3127

 

Riveted the nut plates to the inboard bottom skin and the inspection ports.

 

Installed the pitot mast, pitot tube, and pitot heat control box.

 

Two of the crimp-on quick disconnect terminals on the pitot tube were not properly crimped by Garmin and pulled off when I went to connect them. Disappointing! Unfortunately I had already put in an Aircraft Spruce order this weekend. I’ll wait until I have more stuff to order and get some new connectors.

 

Reinstalled the aileron push tube and torqued the fasteners.

 

Reinstalled the flaps.

 

Today’s Time (hours): 5.0
Wing Time (hours): 280.0
Total Time (hours): 432.0

 

Primed all the remaining wing parts

Drilled holes for and installed angle of attack sensor tubing. Also ran wires for pitot heat.

 

Drilled the rivet holes for all the aileron push tube ends and prepared all the parts for priming.

 

Primed all the remaining wing parts.

 

Installed the aileron and flap gap fairings.

 

Assembled the ADAHRS mounting bracket.

img_2945

 

Today’s Time (hours): 7.0
Wing Time (hours): 249.0
Total Time (hours): 401.0