Bottom Skins Complete

Received the new quick-disconnect terminals and replaced the bad ones. Then I final-installed the pitot tube into the wing and hooked up the plumbing and the electrical. Had to uninstall and reinstall the aileron push tube so that I could get my hands in there.

 

Reinstalled and torqued the aileron push tube in the right wing and installed the aileron trim. Getting those springs on is tricky. I also took the time to bend the actuator arm aft a bit. I just saw a picture on VAF where someone’s springs had almost worn completely through the push tube. Plenty of clearance now. No rubbing.

 

Riveted the nut plates for the right wing inboard fairings and inspections plates.

 

Almost done! Just the wingtips left to do.

 

Today’s Time (hours): 2.0
Wing Time (hours): 285.0
Total Time (hours): 437.0

 

Finished riveting the bottom left skins

Finished riveting the forward half of the outboard left skin.

img_3127

 

Riveted the nut plates to the inboard bottom skin and the inspection ports.

 

Installed the pitot mast, pitot tube, and pitot heat control box.

 

Two of the crimp-on quick disconnect terminals on the pitot tube were not properly crimped by Garmin and pulled off when I went to connect them. Disappointing! Unfortunately I had already put in an Aircraft Spruce order this weekend. I’ll wait until I have more stuff to order and get some new connectors.

 

Reinstalled the aileron push tube and torqued the fasteners.

 

Reinstalled the flaps.

 

Today’s Time (hours): 5.0
Wing Time (hours): 280.0
Total Time (hours): 432.0

 

Cut pitot and added connectors

Just got back from Oshkosh this afternoon. And couldn’t resist heading down to the shop to get something done. Amazing trip with up and back with Jared in his RV-14. Got to meet up with Wes and Joy and met Craig and his son. This was my first time at AirVenture. It was simply amazing but I’m exhausted. I think we averaged 7 or 8 miles walking each day. The airshows were amazing. Especially the night show. Best fireworks and pyrotechnics I’ve ever seen.

 

 

 

I cut the aluminum tubes from the pitot tube assembly using a tubing cutter so that they would clear the aileron push tube when installed in the wing. I added the AN hardware, flared the tubes, and screwed on the adapters. Then screwed the push-to-connect elbows on to the NPT side of the adapters with a bit of Loctite thread sealer. All ready to install.

 

 

 

Today’s Time (hours): 1.0
Wing Time (hours): 267.0
Total Time (hours): 419.0