Match drilled the top and bottom cowls to the cowl hinges.
I disassembled the cowls, deburred all the holes in all the hinges. I coated the inside of both cowl halves with thin coating of resin to seal it all up.
Riveted all the hinges to the cowl halves
Trimmed and sanded the fiberglass inlet ramps and fit them to the top cowl. They gat match drilled to the cowl core just deep enough to hold a cleco to clamp it in place for bonding with epoxy and flox. I didn’t get any pics of the bonding process and I put it back on the fuse to cure before I could get a shot of the finished product.
I did decide to get the oil door done once the epoxy set up sufficiently. It was a pretty straightforward process.
I reinstalled the spinner. She’s coming along!
Just have to drill the attachment holes on the bottom of the cowl and blend in the inlet ramps and the cowl will be complete.
|Today’s Time (hours):||14.0|
|Finish kit (hours):||267.0|
|Total Time (hours):||1001.0|