I finished inventorying and stowing parts from the fuselage kit and avionics.
Crimped the pins onto the aileron trim wires, added a heat shrink tube, and inserted them into the molex connector.
I centered the set the aileron trim using a 9-volt battery to drive the servo. I set the assembly in place on the wing and set the aileron to the neutral position. Then I marked the point where the aileron trim arm rested over the push tube. I remove the push tube and located the tabs 6 inches either side of the center mark. I match drilled and blind riveted them to the push tube. I attached the springs to the tabs.
I clecoed the inboard bottom skins in place on the wings. Ready to rivet.
Today’s Time (hours): | 4.0 |
Wing Time (hours): | 264.0 |
Total Time (hours): | 416.0 |