Finished dimpling everything

Clecoed the left leading skin to the ribs.

Slid the j channel into place and clecoed the starter hole. Then match drilled all the holes from the skin into the stiffener.

Match drilled the aft-most top and bottom holes in each of the ribs.

Disassembled everything and repeated the whole process for the right wing. Deburred and dimpled all the holes.

Dressed the edges of the skin with a file and sand paper.  The cut-outs for the landing lights were pretty jagged. I cleaned them up with an abrasive drum on the Dremel and some sandpaper.

Dimpled the skins with the DRDT2 and scuffed the insides with a scotch brite pad.

Dimpled the rest of the parts.

Everything is ready for priming and assembly.