Began work on Canopy and Window (Section 38)

 

I clamped the rear window in place and carefully adjusted until it was properly centered. I marked it for cutting. I cut the two notches for the roll bar brace brackets with the Dremel and a cutoff wheel. I cleaned it up a bit with files. I trimmed back the protective plastic and remounted and clamped in place. I had to trim a bit further to get the window flush with the window shim on the roll bar. I just filed it back a bit. Ready for drilling.

 

Today’s Time (hours):	3.0
Finish Kit (hours):	10.0
Total Time (hours):	740.0