Cut the J channel to the specified lengths with the Dremel tool and a cutoff wheel.
Clamped the J channel to flange leaving it 1/16″ proud of the flange.
Drilled and clecoed the J channel.
Flipped the lower J channel to the upper flange to finish the holes where the nut plates were on the lower flange. I marked the J channel and set aside for later when the skins go on.
| Today’s Time (hours): | 2.0 |
| Wing Time (hours): | 12.0 |
| Total Time (hours): | 223.0 |
Ron's RV-14A Build Log 