Started practice project #3

I think I’m getting the hang of this. I spent a couple of hours cutting, fitting, drilling, and de-burring this short section of control surface. Next I need to fit and drill the trailing edge angle. Then I’ll disassemble the whole thing and give the paint shop a trial run and shoot primer on the sub-structure and insides of the skins. Then I’ll rivet the whole thing together and move on to building an airplane.

I’m about two hours in at this point.



Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s